Cliente V.
Domanda
Hello, does the monitor work with an SC0500 controller? There are 7 H48050 behind it. Thank you in advance.
In breve
Yes, since firmware 2.8 (generation 2 and Lite): H48050 modules behind an SC0500 controller are read through the controller's Console port, with nothing to configure — state of charge, voltage, current, temperatures, every module and every cell, alarms and status.
Team Pylon-MonitorRisposta ufficiale
Yes: since firmware 2.8, Pylon-Monitor reads H48050 modules behind an SC0500 controller, through its Console port. It detects the high-voltage pack by itself, with nothing to configure. You get state of charge, voltage, current, temperatures, every module and every cell, alarms and status.
To be fully transparent: this high-voltage support was built from real console readings of Pylontech controllers, but we have not yet had a high-voltage pack connected to a Pylon-Monitor in our workshop. If your controller answers differently, the device has a diagnostic page that collects its replies, and we would adapt the firmware.
Questa risposta ti è stata utile?
←Idea: show the remaining running time until 10 % at the current discharge →I can read my Pylon-Monitor at home — how do I see it when I'm away, and is it the same dashboard?
Pubblicato senza nomi né recapiti. I clienti compaiono solo con iniziale e paese.