-
1answer
I made the RJ11 adapter cable from your guide and swapped pins 2 and 3, but I still get no data
The contacts were counted over the 6 positions of the plug, which shifted the wiring by one and left ground unconnected. Count only the 4 metal contacts: 1 to 4. Without ground no data passes, whichever way RX and TX are wired. Also unplug any other console cable while testing.
-
1answer
I am adding a sixth battery, a new US2000C from 2021 still in its box, at one green LED. Do I wait for all the others to be empty?
No need to empty the stack. Per the Pylontech US2000C manual: switch the new battery on alone first and check there is no alarm (it has been stored since 2021); Pylontech recommends the newest battery as master; after connecting, keep the system idle at least 15 minutes or until the charge LEDs differ by one LED at most.
-
1answer
How far can I extend the RJ45 data cable between the Pylon-Monitor and the battery?
With a standard straight RJ45 cable (Cat5e or Cat6), up to about 10 metres is fine. Further away, keep the Pylon-Monitor next to the battery and extend the USB power cable instead: WiFi covers the distance.
-
1answer
Can the monitor be used on its own WiFi network? I don't use WiFi at home.
No: the device's own PylonMonitor-Setup network only serves the first setup. But no internet is needed: a small, inexpensive 2.4 GHz WiFi router with no internet connection is enough for the local dashboard, MQTT and Home Assistant.
-
1answer
How much energy does a Pylon-Monitor Lite consume? Mine runs on a power bank.
Under 0.5 W: at most 100 mA at 5 V, about 2.4 Wh a day. A 20,000 mAh power bank (about 60 Wh really usable) lasts at least about three weeks.
-
1answer
Is the Pylon-Monitor Lite WiFi-enabled, with no cable to the router, only a power supply?
Yes. The Lite connects over WiFi (2.4 GHz). The only cables are the RJ45 cable from the Lite to the battery’s Console port and a USB power supply, such as a 5 V phone charger. It is the same as the model with a screen, minus the display.
-
1answer
WiFi setup: I enter my network and password but the Pylon-Monitor never connects
Set it up at least 5 m from the router, make sure it can join a 2.4 GHz network (a separate 2.4 GHz or guest network helps; avoid "WPA3 only"), re-check the password character by character, and power it from a 5 V / 2 A wall charger. As a last resort, reinstall it over USB at pylon-monitor.com/reset.
-
1answer
Three inverters with three separate stacks of 8 × US2000 — can I monitor each stack with its own Pylon-Monitor in Home Assistant?
Yes. Use one Pylon-Monitor per stack, each plugged into its own master. Each gets its own IP address; give each a different device name in Settings (the default is pylon-monitor.local), and each appears as its own device in Home Assistant.
Published without names or contact details. Customers are shown by initial and country only.