-
4answers
I see every cell of my 5 batteries, but no cycles, health or capacity for the slaves. Why?
Those values come from a health report each battery sends separately. On this stack (one US5000 with four first-generation US3000 as slaves) the raw data showed the old US3000 never answer that report through another battery's console, so their health and cycles cannot be shown. Charge, voltages, current, temperatures and every cell are read normally. Since v3.4.4 the device asks such batteries far less often, which speeds up the rest of the stack. A BMS update from Pylontech later solved it.
-
2answers
With a US3000D as master, why are the stat and info details missing from the raw battery data?
The US3000D console refuses the per-battery commands stat and info with a number. The device therefore reads SOH, cycles, model and serial number for the US3000D master only; voltage, current, charge, temperatures and every cell are read for the whole stack.
-
1answer
What is the normal range for the device temperature?
It is measured inside the device, on its own chip, which warms itself. Devices in service typically show 60 to 70 °C in a room at about 20 °C, a little more in a warm room or a closed cabinet.
-
1answer
Pylontech told me not to exceed 51 V while my US2000 warranty claim is open. What do you think?
Follow it: Pylontech decides the warranty. 51 V is about 3.40 V per cell, which avoids pushing the weak cell at the end of charge. Set on the inverter, it limits the whole stack, so a little usable capacity is lost until the battery is replaced; then go back to 53.5 V max.
-
1answer
On my 8-battery mixed stack some batteries show the wrong model, serial number and cycle count
On large mixed stacks (here 4 × US5000C + 4 × US3000C) a battery’s answer could arrive late and be attributed to the wrong battery. Fixed in firmware v3.4.1 (3 October 2026): every answer is now checked against the battery it came from, and model, serial number and cycles correct themselves within a few minutes of updating.
-
1answer
Why does Pylon-Monitor show 98 % state of health when my inverter shows 94 %?
Both can be right. Pylon-Monitor's combined SOH is the average of the SOH each battery reports, while many inverters weight the pack toward its weakest battery, since that is what limits usable capacity. Each battery's own SOH is shown individually on the dashboard.
Published without names or contact details. Customers are shown by initial and country only.